Setting your Watch

Please follow the instructions below to Wind up your newly received automatic or manual winding watches

Winding Instructions for Most Automatic Watches

Step 1 : Unscrew the knob until it releases without you having to pull the knob out

Step 2 : Rotate the knob in counter clockwise/upwards direction (12 O'clock direction) about 20-30 revolutions. (Please note that while you're at this position while rotating the knob,  the minutes and hour hands should NOT be moving). You should already see the seconds hand moving at the 5th revolution. 

Step 3: Screw down the Crown back inside and enjoy your Luxurious Watch from Shopreplica

Winding Instructions Panerai, Hublots and Other Manual Winding Movement Watches.

Step 1 : While the knob is screwed inside, please rotate the watch in counter clockwise/upwards direction (12 O'clock direction) about 20-30 revolutions. You should already see the seconds hand moving by the 5th revolution.

Step 2 : (For Power Reserve Equipped Watches only) Follow Step 1 until the power reserve fills up completely, Do not over wind the watches or else you could end up damaging the watch.

Setting Date and Time.

Please unscrew the crown (setting knob) of the watch. Turn the knob from up to down (downwards) you will feel the knob loosen and then it will pop out gently.
Pull out the pin very gently and turn downwards OR upwards in some watches to set the date. If you have a Day and Date watch turn upwards to set the day of the week

Please make sure you push turn the pin tightly because most cases of Water Damaged watches are caused due to the pin being screwed up not tight enough.

For a personal assistance in setting your watch please Call our Support Team or drop us an email. 

In addition to the Instructions above, please visit the following URLS on Watch Winding Techniques. 

WINDING ROLEX WATCHES

WINDING PANERAI WATCHES

SETTING YOUR ROLEX DAYTONA